Star Grip Air Installation Nozzle
Already have an air compressor and an air gun? This grip installation nozzle can be attached to any air gun (with a standard 1/8" nozzle thread) for quick tapeless installation and removal of Star grips.
PLEASE NOTE: This tool is specifically designed to be used with Star grips. There is no guarantee that it will work to install or remove other brands of grips, and it is not meant to remove grips which were installed with tape & solvent. Any damage caused to the tool by use with other brands of grips, or for removal of grips that were installed with tape, will not be covered under warranty.
**THIS IS THE NOZZLE ONLY, IT DOES NOT INCLUDE THE GUN. IF YOU NEED THE ENTIRE ASSEMBLY WITH THE AIR GUN CLICK HERE**
Install tool work perfectly with my small air compressor. Worked as easy as advertised. Only took about 45 minutes to put grips on 13 clubs in the bag. Would recommend to any golfer.
Love the Grips and the install tool.
Takes a minute to get used to the air install but after that it’s super easy.
Saves so much time !
Can’t beat the guarantee also.
I HAVE BEEN DOING THIS FOR YEARS. I USE WATER OVER THE TAPE. EITHER APPLY THE WATER BY HAND OR WITH A MISTING SPRAYER TO THE STICKY SIDE OF THE TAPE. AND SLIDE THE GRIP ON OVER USING LOW AIR PRESSURE. THE AIR BLOWS THE WATER OFF AS THE GRIP IS BEING INSTALLED AND THE CLUB IS USUABLE IMMEDIATELY WITH OUT THE MESS AND WAIT TIME FOR SOLVENT TO DRY. REMOVAL IS EASIER AS THE ADHESIVE ON THE TAPE IS NEVER ACTIVATED SO THE GRIP AND BE EASILY REMOVED. FASTER, CLEANER EASIER WITH TH4E SAM PERFORMANCE. SOME GRIPS LIKE PURE AND TITLEIST TOUR WRAP CAN BE INSTALLED DIRECTLY OVER THE SHAFT WITHOUT TAPE USING THIS METHOD. GREAT TOOL
Worked exactly as advertised, grip was installed in a matter of seconds.